Removing Instruments Cluster and Checking Through Wiring in Our DIY Project
- evconversionrider
- Jun 16, 2024
- 1 min read
In this session, I am removing the instruments and identifying any wiring not required for the EV conversion, including ignition, engine management, and charging circuits.
Some of the key points at this stage are:
Labeling everything you unplug or disconnect.
Keep track of everything you remove.
If you are not sure what it is, look it up on the web.
Continue testing systems as you go.
During the upcoming session, you will observe the amount of wiring that is now unnecessary.
Comments